Versatile, Fast set up.
Precise depth control and accuracy makes safe drilling easy and more profitable.

Innovative design, quality construction.
The rig weighs only 3 lbs. but supplies drilling pressure not possible with heavy, cumbersome magnetic drill rigs. The compact design allows the rig to fit where others won't. A non slip triangular shaft accommodates the 3/8" or 1/2" drill motor of your choice.
Multiple attaching options provide versatility. Included drill point templates attach to dial ring screws and position the rig for quickly and accurately for drilling into safe locks. For drilling outside the lock area, you can mount it with our unique Hollow Bore Bolt. The bit goes thru the hollow bolt, and drills into the safe leaving only one hole for easy repair. You can also mount the rig with two self-tapping screws.

Quick Disconnect design allows you to remove and replace the MiniRig in seconds from all mounting options. This exclusive design provides unobstructed access for a scope, inspecting the hole, or change bits.

Optional Accessories: Additional templates are available for electronic locks and a Bolt Saw Guide for cutting bolts on GSA containers.

The Pro Kit includes: The MiniRig and 2 Templates for drilling S&G Mosler, LaGard and Diebold mechanical locks, the Universal Dial Puller, plus a fitted custom case and it all weighs less than 10 pounds. Best of all, it can pay for itself in one or two openings!

$799.00 + shipping

Optional Templates and Accessories:

T3, LaGard electronic locks The following Templates were recently redesigned by Joe Cortie and Dave McOmie T4 Kaba Mas locks. Audicon, Cencon, X07,8,9 and the B52 T7 Drill points for the Ilco 505 and Amsec 10/20. It has an alternative scope hole for Mosler's if you don't know what lock is in the safe, and alternative drill points for the Kaba B52, the LaGard Combogard and the S&G 6120. $65 each #T5 Star, Major, Gary floor safes $80   Uni Temp Universal Template. “UNI-TEMP,” is short for Universal Template. It attaches to the safe’s dial ring mounting screw holes. Uni-Temp uses an X-Y axis system, built-in scales, and an index to allow you to set specific up, down, right, and left measurements from spindle hole center. Lock in your setting, then mount the Mini-Rig and start drilling. $225   Read Ken Doyle's article about the Uni Temp